Since the slats are assembled in halves, and both halves are short enough that I don’t need the tables end-to-end, I rearranged the workshop to a better layout. Previously the workbenches were stretched across the room diagonally (the only way it will fit end-to-end), and it made it difficult to navigate.

This is unfortunately some of the worst dimpling I’ve experienced, so I’ve posted onto the Zenith forum to see if others think it’s worth going back and trying again, or if there are ideas to get a tighter fit on other slats sections.

And here is the completed half of the slat. After building the other 3 halves I’ll set them all aside and hold off final assembly until the wings are done and they can be attached.